单效纤维分离机-Single effect fiber separator
体彩p3图谜第一版下载 www.eoxxe.tw 概述
On the basis of absorbing the advantages of overseas similar products and combining with the actual situation of domestic manufacturers, this machine is a paper breaking equipment developed by our company, which integrates pulping and screening. Its advantages are low power, large output (3-5 times the output of ordinary fiber separator with the same power ratio), high slag discharge rate and easy operation. Compared with other similar products at home and abroad, it has the advantages of better performance, stronger automaticity, higher reliability and more convenient operation. It is a renewal product of the old fiber separator.
The cylinder is designed with abrasion resistance and pressure resistance, and the material is stainless steel or carbon steel. The slurry enters the cylinder along the tangential direction from the entrance, breaks down the raw materials by centrifugal force generated by the high-speed rotation of the rotor, and separates the light and heavy impurities. The light impurities are discharged from the center of the cylinder cover. The heavy impurities are discharged into the sand tank along the tangential direction due to the principle of centrifugal force.
The special shape design of the rotor can effectively separate the light and heavy impurities.
The inner side of the rotor is provided with a cleaning water pipe to prevent clogging of sieve holes.
The rotor blade is made of replaceable wear resistant high strength alloy steel.
The rotor body is cast steel or cast stainless steel (user selected).
(3) Sieve plate
The aperture of sieve plate is from φ2.5 to 6 mm (depending on user needs).
Usually, newsprint and magazines paper use sieve plates with aperture ranging from 2.5mm to 4mm.
Corrugated board and box board use sieve plates with a bore diameter of 3.5mm to 6mm.